Feet Extensions MendelMax

This will raise your MendelMax ~4 inches, which will give you room to mount electronics. I placed a flat piece of thin wood under the main structure, I will mount the electronics on the underside. With these extensions, it will give me the clearance i needed.
I will be cutting roughly 100mm tall skirt to fit inside from corner to corner to hide the electronics.

Notice: They are printing atm and are not tested. Use at your own risk.

Edit: Had to lower the base on the upper part of feet so the holes can line up. If you were using bottomless feet it would have been fine, but i was using standard mendel max feet that have a 5mm thick bottom