Thingiverse
Feiyu G5 Hero 5 Conversion
door jasonmartins
13
Downloads
12
Likes
0
Makes
Using this Mount, you can use your Feiyu-Tech G4 for the Hero5.
I Was able to print it in PLA with 230°C and 2000mm/min on my kossel XL, strength seems to be fine, however, be careful, it is still plastic, not metal as the original piece.
i wasn't able to perform a full test, as i broke my gimbal while turning it on without all cables connected, so be warned!!!
I Was able to print it in PLA with 230°C and 2000mm/min on my kossel XL, strength seems to be fine, however, be careful, it is still plastic, not metal as the original piece.
i wasn't able to perform a full test, as i broke my gimbal while turning it on without all cables connected, so be warned!!!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
