Fence Gate Handle and Latch Pull

I designed a D-handle and Latch Pull Down for my newly installed fence. The D-handle should work on any plastic fence. The Latch Pull Down may not fit your fence hardware so print at your own risk. The hole on the latch was 9.7mm, the angle of the slope on the latch plate is 116 degrees, the thickness of the metal was 2.84mm.

Here are the details.

D-handle for the fence gate:
The white handle has a pocket for 2x strips of 1/2" VHB Automotive 3M double-sided tape. Basically a slightly over 1" wide pocket that goes along almost the entire height of the part. When installed you won't be able to see much of the tape. I used painter's tape to cover the pocket while I primed and spray painted the part. Then I removed the painter's tape and applied 3M Adhesion Promoter to the plastic and adhered the VHB tape to it. I cleaned the fence with rubbing alcohol before adhering the gate handle to the fence surface.

Latch Pull Down:
This part sleeves onto the existing latch and then the