Thingiverse
Feniex 4200 Mini Controller Template
door _JustGrant
7
Downloads
6
Likes
0
Makes
This is a drilling template to mount the Feniex 4200 Mini controller from the back.
Use a 3/16" drill bit and then enlarge the center hole for the wire bundle coming out the back of the controller.
8-32 screws and washers to mount the controller.
the angles on the corners are off a bit, but the overall size is correct to help give you an idea as to where it can fit.
Use a 3/16" drill bit and then enlarge the center hole for the wire bundle coming out the back of the controller.
8-32 screws and washers to mount the controller.
the angles on the corners are off a bit, but the overall size is correct to help give you an idea as to where it can fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
