Thingiverse
Fenix PD35 Diffusive Lightbulb
von joshikirsch
94
Downloads
59
Likes
0
Makes
With this beautiful lightbulb-shaped diffuser you can achieve exactly the style of camping-light you were looking for! It fits my Fenix PD35 Tac just fine, so theoretically any other Fenix flashlights should work, too. (Make sure to read the bottom paragraph!)
Attention: The hole in the bottom of the bulb is exactly one inch wide - just like the head of the flashlight. You need to scale the model relatively to your printers size-offset. Our Ultimaker 2+ required a scaling of 103% and two minutes of sanding were necessary to accommodate a flush fit.
Attention: The hole in the bottom of the bulb is exactly one inch wide - just like the head of the flashlight. You need to scale the model relatively to your printers size-offset. Our Ultimaker 2+ required a scaling of 103% and two minutes of sanding were necessary to accommodate a flush fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
