Thingiverse
Ferris Wheel
por wjordan819
123
Descargas
113
Likes
1
Makes
This was a continuation of my fairground theme. I also wanted to try using gears.
I used a variety of infills depending on the parts. Obviously the smaller parts needed a greater infill.
There are a lot of individual parts to this model. I have tried to keep the part count as low as possible, but wanted to be able to print with as little support material as possible. I have provided full written assembly instructions to ease assembly.
The model stand 22cm (8.5 inch's) tall and 15cm (6 inch's) wide.
I used a variety of infills depending on the parts. Obviously the smaller parts needed a greater infill.
There are a lot of individual parts to this model. I have tried to keep the part count as low as possible, but wanted to be able to print with as little support material as possible. I have provided full written assembly instructions to ease assembly.
The model stand 22cm (8.5 inch's) tall and 15cm (6 inch's) wide.
wjordan819 también publica en
13 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
