Thingiverse
Festool DTS 400 Sander Holder / Bracket
por perfarny
42
Descargas
22
Likes
0
Makes
UPDATE 1/7/2022 - reduced footprint and fine tuned spacing and edges.
A holder for the Festool DTS 400. Things I made sure of with this design:
- The pad is protected throughout - the sides pressure the back plate of the pad, not the foam part, and the bottom of the holder puts zero pressure on the foam.
- Also, to not have the entirety of the sander's weight pulling against the top 'walls', the bottom extrusion lets the top of the dust collection port rest against it (doesn't interfere with hose hooked up), offloading the weight. Probably not needed at all.
- (Can't get this line unbolded :/ ) Optimized to fit snug with protection pad and paper installed, as I use mesh paper. Fits perfectly fine without, too.
A holder for the Festool DTS 400. Things I made sure of with this design:
- The pad is protected throughout - the sides pressure the back plate of the pad, not the foam part, and the bottom of the holder puts zero pressure on the foam.
- Also, to not have the entirety of the sander's weight pulling against the top 'walls', the bottom extrusion lets the top of the dust collection port rest against it (doesn't interfere with hose hooked up), offloading the weight. Probably not needed at all.
- (Can't get this line unbolded :/ ) Optimized to fit snug with protection pad and paper installed, as I use mesh paper. Fits perfectly fine without, too.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
