Festool MFT-3 Shelf Bracket

Festool MFT-3 Brackets for a shelf. Shelf not included. You have to build that out of whatever material you want. I used ½ ply.Size of shelf is up to you. You can adjust the brackets as needed. You will have to remove a couple of the screws under the MFT table to slide the t-slot nuts in there. After that you just align the brackets to the T-Slot nuts and us the M6 screws to tighten. The print has a 15% infill but 25% infill where the M6 Screws connect for extra support. Feel free to adjust if you would like more infill in those areas. You will need 4 T-Nuts and 4 M6 16mm screws. For the shelves I used 3inch screws with nuts not shown in the pictures but you can use what ever you want. Depending on how you build your shelf. You will need 4. I build to shelf to hold the weigh of my Festool track saw and also to fit a standard Festool Systainer. Weight limit is about 10-15lbs.You can print this in PLA. Should hold well. I printed min in PETG-HF just because I had some extra. Hope this is