Thingiverse
Hobby
Go to Model
Fiat keychain
145
Downloads
227
Likes
5
Makes
Old Fiat logo keychain.
Added a 600S version, about 10cm long. Design done in Inkscape and dxf exported to Onshape. Font for the numbers is Sans Serif, tilted 17º. It matches reasonably the available pictures of original logos.
Available publicly in Onshape under Fiat Logo, user Pedro Palma
Added a 600R version, slightly shorter at 8cm. It may be a bit too small to print well, soo you can scale it up in XY only to suit your needs.
Printing is tricky, as the part tends to warp and lift off the printing bed. I did it using 20% infill, two layers top and botton and a concentric print pattern.
Changed the font of the numbers to Univers, as apparently that is the correct FIAT font. The "R" however doesn't follow the same graphical language and is kind of weird, almost as if it was done by someone other than Fiat.
Added a 600S version, about 10cm long. Design done in Inkscape and dxf exported to Onshape. Font for the numbers is Sans Serif, tilted 17º. It matches reasonably the available pictures of original logos.
Available publicly in Onshape under Fiat Logo, user Pedro Palma
Added a 600R version, slightly shorter at 8cm. It may be a bit too small to print well, soo you can scale it up in XY only to suit your needs.
Printing is tricky, as the part tends to warp and lift off the printing bed. I did it using 20% infill, two layers top and botton and a concentric print pattern.
Changed the font of the numbers to Univers, as apparently that is the correct FIAT font. The "R" however doesn't follow the same graphical language and is kind of weird, almost as if it was done by someone other than Fiat.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
