Fiber Optic Suppressor Height Sights

Both of these files were personalized from the Original Glock / Polymer 80 Suppressor Height Sights by kromehawk.

Print the front sight with the screw hole facing upwards, and the rear sights can be left as its placed in your slicer.

These are made to be able to fit 2mm (0.078") fiber optic from Truglo. Both Rear and Front have serration to be able to insert the fiber optic. For the front sights you will need a small mallet to hammer it all the way down. With wire cutters I can the fiber optic flush with the sights. The rear sights, made the inserts little bit bigger than the fiber optic, so before you insert the fiber, with a toothpick, dab a small amount of super glue inside the serrations then insert the fiber optic.

Front sights the best screw will need to be the "long version" which is the 0.245". The short screw will work too, but to make sure its tight as possible and wont back out, use Loctite, or little super glue works great too.

Print Resolution: 0.12