Thingiverse
Fibreglass Pole Antenna Support
by 2e0txe
4
Downloads
1
Likes
0
Makes
This topper was created to support both vertical wire antennas and dipoles on my Sotabeams Tactical 7000HDS fibreglass mast.
There is a 6mm hole for sliding over the top element and an 8mm hole for securing your antenna wire or paracord for a dipole center.
Designed in Tinkercad, quick and dirty print.
There is a 6mm hole for sliding over the top element and an 8mm hole for securing your antenna wire or paracord for a dipole center.
Designed in Tinkercad, quick and dirty print.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
