Fidget d20

A d20 die inside a box frame, mostly just to fidget with! It could possibly use some fine-tuning, but I won't likely revisit it any time soon, so here it is as-is.

There are two models - one with numbers, one without. The numbers can print a bit wonky.

These models should not require supports, although there will be some cleanup (snipping off any droopy bits and such). I printed them with 0.2mm layer heights and a brim enabled on both the inside and outside of the model (to keep the die from slipping during printing), which you'll also have to snip off. Be careful not to break the frame.

If you scale them up (they're quite small - the box frame is 20mm across) you will need supports and there will be A LOT of cleanup.