fidget gun slider

Seen this fidget toy everywhere but couldn't find a good STL for one so here we go!Consists of 7 pcs. You will need one PEN SPRING, 10 MAGNETS (6mm x 2mm) and C.A. Glue. The hinge is joined with a piece of 1.75 mm filament.Assembly is pretty straight forward. It all should fit together. I printed this on my bambu lab P1S . Sand paper is your friend. Make sure to work in the parts a bit to get them sliding smoothly. Also if needed I can make adjustments.My original file. Obviously not my creation. Just sharing.Quick Assembly:Pick one side of the body, place SLIDER in top grove of body.Install SPRING in slotInstall RINGCarefully apply some CA glue on the inside wall of the lower body to join them. Make sure not to get it in the RING areaInstall 10 MAGNETS - Use CA if neededInstall the BRIDGE - Use a piece of filament to complete the hinge (It will be a little tight - cut flush)Slide TOP into the grove of the BRIDGE - Work it back & forth to make it slide smoothInstall WEDGE in front