Fidget RotaryClickSpinner

Fidget RotaryClickSpinnerSpinner with two magnetized rotary knobs and a very satisfying ratchet mechanism. UPDATE for M3: Added the files for a M3 Version also because of an user request. But keep in mind due the wider diameter of the M3 brass inserts the clickspiral shaft will be weaker. External Hardware:1x countersunk screw M2.5x12mm1x countersunk screw M2.5x20mm2x M2.5 x 4mm brass heatinsert2x 608 bearing14x D6x3mm magnets Assembly: Heat Inserts:Press the M2.5x4mm brass heat inserts with an soldering iron into the clickspiral on both sides. Make sure that they are straight and flush with the top and bottom. Clickmechanism:install the clickspiral into the clickroller. Be aware that there is only one right direction for it to fit in. If it is installed the wrong way the click operation might suffer. Clean bearings:To make sure the operation of the spinning part is smooth, give the 608 bearings a good wash in isopropyl alcohol to get rid of all the grease inside. To protect them from