Fidget Spinner - Clicker Coin

Fidget Toy - Clicker Coin by Matt Tranchina from Printables. ---- The following is the description from the Printables by Matt ----This is a 4 part fidget toy designed to print quickly and easily. It has a satisfying clicking sound and feel.I recommend printing the wheel and clicker in glossy filament over matte filament. If they are printed in matte filament they tend to not click as loud/smooth.If the wheel seems like it is getting stuck or not clicking smoothly, try taking the wheel out and wiping along the inside teeth to clear any debris. If that doesn't work, try printing the wheel again with elephants foot compensation. I recommend doing this anyway. Additionally, after snapping the clicker into the base, the clicker should have some wiggle room and should not be a very tight fit. If the fit is too tight, then the clicking sound will not be as loud.And finally, the top part may require a little bit of extra force to snap on at first. Just make sure the two alignment pins on