Thingiverse
Fidget Spinner Go
door millemnm
81
Downloads
64
Likes
2
Makes
This is a Dual Spinner Version of my Tri-Spinner that can be found here: http://www.thingiverse.com/thing:2109834.
The Boutons stay in best when hot glued so I made one that doesn't have the insert so it uses less filament.
I found that because it is long and narrow it is much easier to carry in your pocket than a tri-spinner.
Uses 608 ball bearings (8mm x 22mm x 7mm). It is really fun and addicting. You can use it in school or work because its silent. It has a really pleasurable to spin. It is very well balanced and can be balanced on the tip of your finger easily.
*This is based on http://www.thingiverse.com/thing:1827241. I had to redesigned it from the ground up because even though the ridges look awesome, after a day of using it my finger became really red and irritated. By removing the ridges it still looks cool and feels good too.*
The Boutons stay in best when hot glued so I made one that doesn't have the insert so it uses less filament.
I found that because it is long and narrow it is much easier to carry in your pocket than a tri-spinner.
Uses 608 ball bearings (8mm x 22mm x 7mm). It is really fun and addicting. You can use it in school or work because its silent. It has a really pleasurable to spin. It is very well balanced and can be balanced on the tip of your finger easily.
*This is based on http://www.thingiverse.com/thing:1827241. I had to redesigned it from the ground up because even though the ridges look awesome, after a day of using it my finger became really red and irritated. By removing the ridges it still looks cool and feels good too.*
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
