Thingiverse
Fidget Spinner Lego Cap
von mmoore0
8
Downloads
7
Likes
0
Makes
This thing is a fidget bearing cap with lego studs. It can be installed on any of the bearings. There are four studs that should support a mini-fig or other small lego piece.
Printing will require supports. I printed it with the Lego side up with supports set to "touching build-plate". I have also tried printing with the Lego side down, but clean-up in this orientation was quite tedious.
Printing will require supports. I printed it with the Lego side up with supports set to "touching build-plate". I have also tried printing with the Lego side down, but clean-up in this orientation was quite tedious.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
