Thingiverse
Fidget Spinner - M8 weight
by ysmilda
23
Downloads
16
Likes
1
Makes
Edit 1: I added a Thumb cap. I like it better without, but whoever needs it can use it.
I wanted to have a fidget spinner, but I didn't want to put in three or more bearings. So I designed a spinner which uses M8 nuts as weights, and it works great! It is also a bit smaller than the ones with bearings, making it easier to spin with small hands.
It is designed to have a tight fit, but if needed the parts can be taken out after putting them in.
With cleaned bearings, it spun up to one minute and with uncleaned ones it gets up to 15 seconds of spinning.
I wanted to have a fidget spinner, but I didn't want to put in three or more bearings. So I designed a spinner which uses M8 nuts as weights, and it works great! It is also a bit smaller than the ones with bearings, making it easier to spin with small hands.
It is designed to have a tight fit, but if needed the parts can be taken out after putting them in.
With cleaned bearings, it spun up to one minute and with uncleaned ones it gets up to 15 seconds of spinning.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
