Thingiverse
Fidget Spinner Thumb Rest
by joshterrell
5
Downloads
7
Likes
0
Makes
I really liked the thumb rest on this adafruit spinner design. However, one side is form-fitted for the thumb the other side wasn't. Most thumb rests I see on Thingiverse were 2 parts where one side was completely flat. Not very comfortable. So I redesigned it so both sides were the same. It made it into 3 parts instead of 2, but the end result is much better.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
