Thingiverse
Fidget Spinner with nuts
por Cycon
3
Descargas
9
Likes
0
Makes
This was made from a tutorial by The 3D Printing Nerd, go check his YouTube channel out.
NOTE: v02 has thicker connections so that it is stronger, plus rounded edges for smoother fidgetting
NOTE: If the nut or bearing holes are too small, quickly pass a flame around the hole, then slightly push on the edge in a circular motion with something like a rod or a screw drive(but not the head. DO NOT HEAT FOR TOO LONG. This method takes a bit of practice, just be patient. ALSO, if you do not want to do it the fast and pretty way, you can always take a file to the inside.
NOTE: Oh and before I forget. they are 1/2 in nuts. But if you meausure flat edge to flat edge it is 19 mm and from point to point it is about 22 mm. The inner diameter is 12-13mm
NOTE: v02 has thicker connections so that it is stronger, plus rounded edges for smoother fidgetting
NOTE: If the nut or bearing holes are too small, quickly pass a flame around the hole, then slightly push on the edge in a circular motion with something like a rod or a screw drive(but not the head. DO NOT HEAT FOR TOO LONG. This method takes a bit of practice, just be patient. ALSO, if you do not want to do it the fast and pretty way, you can always take a file to the inside.
NOTE: Oh and before I forget. they are 1/2 in nuts. But if you meausure flat edge to flat edge it is 19 mm and from point to point it is about 22 mm. The inner diameter is 12-13mm
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
