Fidget Toggle Switch spring with fixed positions

Attribution and OverviewThis is an alternative spring part for the “Adjustable Fidget Toggle Switch” by Kriswillcode. I believe I am sharing this in the same way as it is being shared, as requested. This is non-commercial. You will need all the other parts from Kriswillcode to make the full model, this is just the spring piece. By adding 6 small ridges onto the spring piece, it stops the slider from moving back into the middle position as you repeatedly toggle the switch. There are five actual positions you can have it the slider in, and the position closest the switch is slightly back from flush. That is just the way it turned out, and I'm ok with it. If you are particularly OCD you might not feel that this is “perfect”, if so, let me know and I might spend the time dialing it in to change this. Even still, it is nice to not have it move once you set it. It is a small part, and a quick print, so perhaps give it a go? To PrintYou need to print these on their SIDE, which is a bit tricky