Fifine microphone stand

Desk stand for the FIFINE A6T microphone. Designed with a reduced desk footprint in mind as it allows to set the microphone as low as possible to fit under my monitor. The microphone can be at a very low angle to minimise the height as much as possible. I was not satisfied with the other designs available that had the mic at an awkward angle that made it not oriented right to record good audio as the mic was not oriented toward the speaker. Extremely stable even at a high angle with the very low center of gravity It uses the original washers and nuts to clamp : unscrew the original support and take the screw, nut and the two black plastic washers The PLA print profile reinforces the pinching point of the stand where the mic is attached to minimise breakage, (printed with marble PLA in picture)