Thingiverse
FIFO Can organizer
by scruggsdj
253
Downloads
177
Likes
0
Makes
FIFO Can Organizer
Designed with the dimensions of the Prusa Mk3S build plate in mind. Each separate layer prints with all of the 8 pieces in the files. They can then be connected using the rods and either double pins or single pins depending on your needs. The wafers are there for stacking them on top of one another.
When I printed mine, I needed to use glue to hold the pins in and zip ties on the rods to make sure the weight of the cans wouldn't cause too many shifting issues.
No supports should be needed. I designed a small piece on all of the sections were the pins go that acts as a support for that overhang. This is by no means a perfect solution, but it allows it to print decently without needing all the supports.
This is definitely not a perfect design. If you have any feedback, I would love to hear it.
Designed with the dimensions of the Prusa Mk3S build plate in mind. Each separate layer prints with all of the 8 pieces in the files. They can then be connected using the rods and either double pins or single pins depending on your needs. The wafers are there for stacking them on top of one another.
When I printed mine, I needed to use glue to hold the pins in and zip ties on the rods to make sure the weight of the cans wouldn't cause too many shifting issues.
No supports should be needed. I designed a small piece on all of the sections were the pins go that acts as a support for that overhang. This is by no means a perfect solution, but it allows it to print decently without needing all the supports.
This is definitely not a perfect design. If you have any feedback, I would love to hear it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
