Thingiverse
Fighter Brief Marker Holder
by Doc1885
5
Downloads
2
Likes
1
Makes
No more duct taping caps together!
Here's my take on the classic expo marker holder for pilot briefings. Holds 4 standard sized expo markers with a nice flat surface for personalization (.step file included) and 3 5x2mm holes for neodymium magnets if you so desire.
It's slim enough to fit in your flight suit pocket,and allows you to switch out the marker caps if they ever go bad.
prints just fine without supports if you lay the back side flat.
Just uncap your marker, snap the cap into place, and you're ready to draw those perfect lines. If you need to swap in a new cap, use a sturdy pair of scissors to help you snap the cap back out.
CP!
Here's my take on the classic expo marker holder for pilot briefings. Holds 4 standard sized expo markers with a nice flat surface for personalization (.step file included) and 3 5x2mm holes for neodymium magnets if you so desire.
It's slim enough to fit in your flight suit pocket,and allows you to switch out the marker caps if they ever go bad.
prints just fine without supports if you lay the back side flat.
Just uncap your marker, snap the cap into place, and you're ready to draw those perfect lines. If you need to swap in a new cap, use a sturdy pair of scissors to help you snap the cap back out.
CP!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
