Fighting Type Pokémon Card Case

Decorative card case for a Pokémon fighting type! Fits a standard card slab off the internet, not a graded slab. It's just print in place and the supports for the corners came off by hand when I used a generic PLA. Pauses in the corner pieces where the Pokémon symbol is for a filament change, so that the symbols are clearly visible. Tight fit so that the card can't fall out once 3/4 corners are pressed in. Toleranced on the tighter side for the same reason, I pressed down on a desk to properly pop them in, and used a screw driver to press the corners through the back to remove. Made for Josh, happy Chrismukkah if you ever see this!