Thingiverse
Figure Display Stand
door Testedcom
57
Downloads
48
Likes
0
Makes
Designed for 1/8-inch material to be laser cut. Tested with clear and frosted acrylic. Required ~3 sheets of 12x20 material, if using Glowforge.
Kerf offset not built-into the file, so add as needed (.005 is a good starting point).
Design is composed of 4 exterior walls + 38 interlinked interior pieces connected with slot joint. platform is ~5"x5"x1.5"
Kerf offset not built-into the file, so add as needed (.005 is a good starting point).
Design is composed of 4 exterior walls + 38 interlinked interior pieces connected with slot joint. platform is ~5"x5"x1.5"
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
