Figure display stand with lattice risers

Four-Platform staggered display stand for figures.
Round bases from 25-32mm should fit inside the fingers, the figures I show here have much larger bases sitting on top of the fingers.
Platforms at 25, 50, 75 and 100mm
To demonstrate the strength/stiffness of the design, I put 2" diameter steel ball bearings on the three tallest platforms for one of the pictures. I don't think I'd want to leave that much weight on printed resin risers, but they seemed stiff enough.
In one screen-shot, I show five of these arranged to keep pattern spacing (just shy of 64mm center-to-center keeps the riser pattern).
I like the look of this smoky gray resin.
I had the slicer add drain holes at the center of each riser so any resin trapped in the base would drain easier.