Thingiverse
Filament Adapter Ring
por shingabiss
2
Descargas
1
Likes
0
Makes
This is an adapter for the 1.167" diameter filament roll holder that comes with the Flashforge Creator Pro.
Most of the filament I buy comes with a 2.0" center hole in the roll. Putting these on the skinnier holder can lead to tangles so I designed this adapter to fit into the 1.167" diameter which then broadens out to 2.0" with a flange on the outer edge.
Most of the filament I buy comes with a 2.0" center hole in the roll. Putting these on the skinnier holder can lead to tangles so I designed this adapter to fit into the 1.167" diameter which then broadens out to 2.0" with a flange on the outer edge.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!