FIlament and Cable Guide for CTC / FlashForge / Duplicator / Replicator

I had some trouble with my filament guides that were plopping out of the original plate. (Certainly the one where I had no filament inside !).

I was inspired by the following design. http://www.thingiverse.com/thing:340031. I had only specific M8 Push-In Pneumatic connectors for 6mm tubes. So I had to modify the design.
But like always you just get an STL file that you can not easily modify it.

I also added a small plate to close the opening to grip all the cables.
The pictures do not reflect my latest one that is mounted. I decided to place the fan cables beneath the plate. This is better for the cable harness.
N.B. : There are 34 mm between the 2 holes of the extruder ! My printer is a Flashforge Creator Dual