Filament Bot Sensor Holder

So I finally got tired of my rigged up filament sensor hanger. So I made a new one. I based my design off of the original filament guide that I had from ToddsWorld. I improved upon it a little by adding a support leg to the C clamp that attaches to the printer itself. The mount is sturdy, and you can glue it together for extra strength. I didn't and so far so good. I used 2.5 x 10mm screws with a lock nut. The holes are 3mm though, I just used what I had around.

It was created in Vectary, and I sliced it with Simplify 3D. This is the best orientation I found that uses the least amount of support.

Here is a link to the original filament guide, https://www.thingiverse.com/thing:3405470

I might re-work the hanger again.... It is functional and does it's job, but I can make it look better LOL.