Thingiverse
Filament Box Feeder
door man1ac
161
Downloads
96
Likes
1
Makes
Hey guys,
wanted to build a filament box and used some design of feeders to get the filament out. Wasnt quite satisfied with the versions that were available so I made my own.
The Feeder itself is from Amazon:
https://www.amazon.de/SIENOC-PC4-M6-Pneumatische-Schnellverschraubung-Gewinde/dp/B06XXCJ8TB/ref=sr_1_3?ie=UTF8&qid=1533655077&sr=8-3&keywords=pc4-m6
Use some PFTE Tube - fits perfectly.
In my Version the feeder is held by an inside part that. Both parts are fixed with M3 Screws (Round head with hex wrench). The Nuts should fit in the inner part.
I make the box airtight by using (on both parts) double sided tape. Works like a charm!
wanted to build a filament box and used some design of feeders to get the filament out. Wasnt quite satisfied with the versions that were available so I made my own.
The Feeder itself is from Amazon:
https://www.amazon.de/SIENOC-PC4-M6-Pneumatische-Schnellverschraubung-Gewinde/dp/B06XXCJ8TB/ref=sr_1_3?ie=UTF8&qid=1533655077&sr=8-3&keywords=pc4-m6
Use some PFTE Tube - fits perfectly.
In my Version the feeder is held by an inside part that. Both parts are fixed with M3 Screws (Round head with hex wrench). The Nuts should fit in the inner part.
I make the box airtight by using (on both parts) double sided tape. Works like a charm!
man1ac publiceert ook op
9 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
