Thingiverse
Filament box
von yanew
3.7k
Downloads
2.9k
Likes
1
Makes
Box for filament.
It's modified tool box https://www.thingiverse.com/thing:4582978.
210.210.100 are internal dimensions.
The groove for the seal is provided directly for filament A82-85 1.75 mm, but maybe it is better with an elastic band 2 mm. In fact, even the softest filaments are not as soft as an elastic band.
The box is parametric and can be any size, including the thickness of the box and the ribs.
It need:
M3x40mm for the latch and the hinge.
M4x8mm for spool holder.
Depending on the bridging capabilities of the printer, it may be necessary to drill the hinge of the lid with a 3mm drill bit, it must rotate freely around the axis.
Gcode files are only for Prusa MK3S and the box is 205.210.100 with modified printer setings(bed size and extruder position) to be able to print 215mm on the Y axis.
I haven't printed and tested the desk stand but it should be ok.
I added a modified version with silica clips and the filament the output does not need support.
S
It's modified tool box https://www.thingiverse.com/thing:4582978.
210.210.100 are internal dimensions.
The groove for the seal is provided directly for filament A82-85 1.75 mm, but maybe it is better with an elastic band 2 mm. In fact, even the softest filaments are not as soft as an elastic band.
The box is parametric and can be any size, including the thickness of the box and the ribs.
It need:
M3x40mm for the latch and the hinge.
M4x8mm for spool holder.
Depending on the bridging capabilities of the printer, it may be necessary to drill the hinge of the lid with a 3mm drill bit, it must rotate freely around the axis.
Gcode files are only for Prusa MK3S and the box is 205.210.100 with modified printer setings(bed size and extruder position) to be able to print 215mm on the Y axis.
I haven't printed and tested the desk stand but it should be ok.
I added a modified version with silica clips and the filament the output does not need support.
S
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
