Filament cleaner

This filament cleaner is a remix of https://makerworld.com/en/models/441169 Here are the changes and improvements made:The cleaner now requires only 2 pcs of Ø4x2 mm magnets, or Ø5x2 mm (by request) instead of 4.The hinge has been repositioned away from the body to ensure a more consistent closing action.After printing the original model, the walls close to the hinge were pressing against one another, resulting in the filament cleaner being springy and able to open by itself. To address this issue, the height of the wall near the hinge was slightly lowered, and a small fillet was added to the outer edges.A small rib was added near the outlet to apply additional pressure on the sponge against the filament in this area, allowing for better dust collection.To allow for a thinner sponge (~10 mm thick) and make filament movement easier, the internal height was slightly reduced. Printing:Print with a layer height of 0.15-0.16 mm and 100% infill, using the material of your choice. Use a piece