MakerWorld
3D Printer Accessories
Model downloaden
Filament Clip Pro
27
Downloads
21
Likes
10
Makes
Probably the 100th of those you have seen, but this one combines the pros of most of them! low profile AMS 2 safe only uses 0.5 g of material can be installed at 8 positions 0/90° and +-45° easy install, just click in place Please use PLA. Please Please PLEASE clean your plate. DO NOT disable calibration. For installation: There are two versions. Wide pin spacing for 0/90° where the holes run horizontal/vertical right under the stock filament holes. Narrow pin spacing for +-45° holes in between. Watch out for the curvature of the clip to match the spool and push it into the outer most rows possible until you hear a click.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
