Filament Cutter

Filament Cutter Parts, required : 1x original Bambulab filament cutter2x M3 x 30mm carriage bolts * included with the P1 series printers *2x 4 x 25 mm springs *Pen Springs* Assembly :Screw in the two bolts from below, then insert the springs. Insert the cutter into the top section and insert a strand of filament to lock it in place. Cut flush. Insert the top into the bottom and screw it in. Press firmly downwards and tighten the screws so that they are just inside the lower piece.Tips : If you dont screw in the filament cutter you may run into it blocking the filement from entering the hole. You just have to flip it upside down to fix the issue. Other than that, it's a quick, easy, and satisfying way to cut filament when needed.