FILAMENT DRUM ADAPTOR

Summary - This component allows industry standard filament rolls to be mounted upon the factory replicator filament draw while extended (requires drilling a hole through existing mounting boss) - parts required to complete - (x1) 5.0mm drill bit / (x1) M6x15 bolt and nut / (x2) M6 flat washers

Method - a) print component b) extend factory filament draw until locked and drill existing mounting boss at center c) place M6 washer onto M6 bolt and thread through printed component until bolt bottoms out d) screw entire component and bolt into 5.0mm drilled hole and screw down until component faces are together e) to mount filament roll undo adaptor, place new filament roll onto factory mount and screw adaptor on f) use locking nut if desired g) remove ptfe guide tube and thread through existing primary port in filament draw (correct filament roll direction = clockwise, see pictures below)