Thingiverse
Filament Dry Box
von Jensen_75
8
Downloads
3
Likes
0
Makes
Filament Dry Box
This filament Dry Box uses the Sterilite P/N 1933, 32 quart gasket box which can be found at Home Depot or Menards which is local to me.
All parts can use either 4-40 x 1/4 or M3 x 8mm hardware.
PVC Pipe is 1in inner diameter. and measures 15 1/8 in or 385mm.
The bottom screw of the Holder-One-Body is 5 1/4 in from the bottom of the bin.
Bowden connectors are M10 Thread for the Filament-Port.stl and the hole into the bin is 5/16 in
The PTC-Plug was snug fit with a 4mm PTFE tube with my printers tolerances but your part may vary.
This filament Dry Box uses the Sterilite P/N 1933, 32 quart gasket box which can be found at Home Depot or Menards which is local to me.
All parts can use either 4-40 x 1/4 or M3 x 8mm hardware.
PVC Pipe is 1in inner diameter. and measures 15 1/8 in or 385mm.
The bottom screw of the Holder-One-Body is 5 1/4 in from the bottom of the bin.
Bowden connectors are M10 Thread for the Filament-Port.stl and the hole into the bin is 5/16 in
The PTC-Plug was snug fit with a 4mm PTFE tube with my printers tolerances but your part may vary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
