Filament Dryer Base

This set of parts, with a few additional parts, turns an inexpensive cereal storage container into a filament dryer complete with a humidity display. The filament can be used without removing it from the container.

Parts List
(1) Dryer Base with wheels (printed from the provided stl file)
(4) Bearings, 5 x 16 x 5 mm, 625-2RS available in quantities on Amazon
(1) Mini Digital Thermometer Hygrometer by TASOGEN available in quantities on Amazon
(1) Cereal Container Storage Dispenser by Plastic House available on Amazon

Assembly
After printing the Dryer Base parts and removing the supports, install a bearing into each printed wheel. Then press each wheel (bearing side first) onto each of the four shafts of the main base. The humidity display snaps into the bezel. Drop the completed base into the cereal container. Drill a .125" hole in the container top approximately as shown in the photo. NOTE: use a countersink bit to widen the hole on the inside surface to prevent the filament from bin