Thingiverse
Filament Dust Filter (Foam)
by tmanhchiri1
0
Downloads
0
Likes
0
Makes
This is a filter I made to keep dust off of my filament.
Scale to 140% or more.
Supports Required.
*IMPORTANT*
*To give the "hinge" more flexibility heat the print with a lighter or heat gun prior to clipping it shut on the filament.
* You will need a small cylinder piece of foam (or cube with sides shaved works fine) as the filter for the dust, simply cut a slit in the foam down to approximately the middle (you could probably cut it completely in half and have no problems but I have not tested).
Scale to 140% or more.
Supports Required.
*IMPORTANT*
*To give the "hinge" more flexibility heat the print with a lighter or heat gun prior to clipping it shut on the filament.
* You will need a small cylinder piece of foam (or cube with sides shaved works fine) as the filter for the dust, simply cut a slit in the foam down to approximately the middle (you could probably cut it completely in half and have no problems but I have not tested).
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
