Thingiverse
filament guide and sensor support
door lucajust
3
Downloads
1
Likes
0
Makes
This complete filament guide allows you to install the filament sensor away from the extruder motor to easily install a different motor, such as a Dual drive.
In the design there are two files to use 8mm ball bearings (22mm x 7mm, 8mm bore) or bearings with 6mm bore.
They are needed:
- 3mm bolts
- 3mm nuts various sizes
The project wasn't completely developed by me, so I want to thank the author who contributed, who is not present on thingiverse.
In the design there are two files to use 8mm ball bearings (22mm x 7mm, 8mm bore) or bearings with 6mm bore.
They are needed:
- 3mm bolts
- 3mm nuts various sizes
The project wasn't completely developed by me, so I want to thank the author who contributed, who is not present on thingiverse.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
