Thingiverse
Filament Guide arm
by ChrisN909
8
Downloads
7
Likes
0
Makes
Filement guide from the spool.
Uses 3x M4x10 screw and nut.
2 screws and nuts should work aswell.
Also uses a piece of Ø4 Bowdentube.
Depends on the printer but the tube should stay in place because of frictionfit or else a drop of superglue / instantglue.
Uses 3x M4x10 screw and nut.
2 screws and nuts should work aswell.
Also uses a piece of Ø4 Bowdentube.
Depends on the printer but the tube should stay in place because of frictionfit or else a drop of superglue / instantglue.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!