Filament guide for Ender3 V2

This is a remix of https://www.thingiverse.com/thing:2920344
The change I've made was to remove a portion in the base of the part because the Ender 3 V2 has a brass thread for the Z rod. That brass thread protrudes upwards and doesn't allow the original design to sit flush over the brass thread.

Printing:
I used Cura.
I'm a fan of extra walls over infill.
3 walls will give this a bit more strength since it's a small part.
20% infill or 100% won't matter for such a small part.
Speed = 40mm/s produced nice results.
Layer height = 0.2mm
Initial layer height = 0.3mm
Initial layer horizontal expansion = -0.15mm. This will mitigate elephant foot. Notice this is a negative value.
Support: Tree, zigzag, touching buildplate
Support interface density= 11.11