Thingiverse
Filament guide for spool holder
von LeHof
3
Downloads
2
Likes
0
Makes
Filament popping off the spool to the side, looping tight around your rod and tightening? Causing failed prints due to starving your extruder?
Simply drill two 10mm holes on either side of your spool rod. Insert guide. Feed filament through and you are back to printing.
Compatible with Quick change spool holder http://www.thingiverse.com/thing:98893
Simply drill two 10mm holes on either side of your spool rod. Insert guide. Feed filament through and you are back to printing.
Compatible with Quick change spool holder http://www.thingiverse.com/thing:98893
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!