Thingiverse
Filament Guide Pulley Halves
von jonseejon
3
Downloads
1
Likes
0
Makes
1. Chamfered the edge of the hole to ease insertion of the bearing.
2. Slightly increased the hole diameter to ease insertion of the bearing.
3. Changed to a 12 sided polygon, just because I like to watch it go 'round (still works with the original retainer).
2. Slightly increased the hole diameter to ease insertion of the bearing.
3. Changed to a 12 sided polygon, just because I like to watch it go 'round (still works with the original retainer).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
