Thingiverse
filament guide
von Blank_Disk
2
Downloads
1
Likes
0
Makes
this is a filament guide for geeetech reel holder, its 5mm at either end to fit over the spool carrier, also acts as a handle.
I also put a piece of ptfe tube in mine to guide filament as some spools are wound to tight, this seems to solve the problem of tangling.
I also put a piece of ptfe tube in mine to guide filament as some spools are wound to tight, this seems to solve the problem of tangling.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
