Thingiverse
Filament Guide
door FireGodSpeed
0
Downloads
0
Likes
0
Makes
Easy to print filament guide, use supports touching baseplate for the filament side.
I used a M4x12mm screw, instead of the m4x6 that was installed before.
(The Hole for the screw is 5mm in Diameter (screw =m4). I used a m4x12mm)
I used a M4x12mm screw, instead of the m4x6 that was installed before.
(The Hole for the screw is 5mm in Diameter (screw =m4). I used a m4x12mm)
FireGodSpeed publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
