Filament Hanger

I made these to hold my filament! It can fit about 16 rolls on these 4ish foot long dowels. You'll need a 25mm dowel. I think the one I bought at home depot was 1" x 72". I cut it down to my shelf storage size. You'll need a little bit of persuasion to get the dowels to fit. I used a hammer to lightly tap the print onto the dowel, and I used a piece of wood to protect the print while I hammered. A rubber mallet would probably work better. Let me know if you need a larger tolerance and I'll upload one. You'd probably need a 3rd hanger in the middle of the dowel to get them to hold heavier weights and not sag over time. The current hangers wont slide to the middle easily unless sanding is done. But like I said if you need them larger, let me know. You could probably scale the print up a small amount if needed as well. This is one of my first designs and I'm obsessed! Would love to work on any designs people need. Leave a comment of what you need and I may have