Filament Heated Dry Box

This is a heated Filament Dry Box that can allow filament to be printed straight from the box. The bowden tubes can be moved to the extruder at print time. The tubes have plugs at the enclosure bungs to seal them when not in use. This requires wiring 110V AC so there is a hazard risk if you are not knowledgeable about the wiring please get help. I wired a 10amp breaker between the controller and heater/fan for safety. I also used a bulkhead main plug for supply power. A bulkhead gland could be used to save cost. All holes in the box were sealed with silicon adhesive. There is a descendant stand on the lid. The photos show my implementation. I purchased small cloth bags and pore the descendant into the bag then place on the shelf. Once you complete the build it can take a few days to reach single digit humidity depending on how dry the air is to start with. Instructions for setting the temp and humidity limits can be found on YouTube for the controller. Its very simple.