Thingiverse
Filament Holder
von AimlessDrifter
5
Downloads
3
Likes
0
Makes
This can hold 4 strands of filament, for easier access to the ends when changing colours - or print 2 (one for each side) to hold 8 colours. Makes it a bit easier to find those ends when changing colours, especially if spools are on a rolling mechanism.
Designed using Design Spark Mechanical (Available for free here: https://www.rs-online.com/designspark/mechanical-software). Printed in PLA with Anet A8, no supports are needed.
Designed using Design Spark Mechanical (Available for free here: https://www.rs-online.com/designspark/mechanical-software). Printed in PLA with Anet A8, no supports are needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
