Filament holder

# Filament - holder
Parts for a filament holder. Used on a Styropor/Styrofoam box, But should be useful on plastic boxes, too.

## Additional content

### Boxes used

Stryopor/Styrofoam box
Outside measurements:
Length 54cm
Height: 30cm
Width: 35cm

### Pipes
Standard-Plastic pipes you can find at the DIY - center. Diameter used: 3cm. But smaller and wider options up to 3.5cm can be used.

# How it is done
No need to care about support, plate adhesion or quality. Draft (0.3mm) works just fine. You might want to go to 0.2 or 0.1 for the description plates

## Mounts
The mount inside for the pipes are `halter-innen.stl'. You need two for each pipe. Outside is `halter-aussen.stl`. You might not need the outside elements if you use more stable boxes like hard plastic

## Front Plates
As they are symetric you can use this for inside and outside. This time you can skip the inner part on more stable boxes.

You can print the plates in the color of the filament. Use `